Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Control of the PPP interface

Jamal Feb 9, 2017 10:02 AM

Hello,

I'm using CR300 datalogger and I want to controle PPP Interface.

I tried these two instructions: SetStatus("pppInterface",0) to deactivate and SetStatus("pppInterface",1) to activate.

But the PPP interface  is always inactive.

Thanks.

smile Feb 11, 2017 09:00 PM

Hi

Perhaps, before you activate and deactivate the PPP with status, I believe it is necessary to enable the PPP.

Try to use the PPP page in the "Device Config Utility".

So you can set the port, the string, the answer and more.

Smile

Log in or register to post/reply in the forum.