RETIRED ›
This product is no longer available. Some accessories, replacement parts, or services may still be available.

Imagen no disponible

Services Available
Repair No
Calibration No
Free Support No

Overview

The CM106K Tripod Kit contains the hardware necessary to construct a 3 m (10 ft) tripod. It is designed to save shipping cost by having the customer obtain steel pipe and a grounding rod locally. The kit contains the parts to assemble the pipes into a tripod, including feet, joints, bolts and nuts, lightning rod, and other parts. The customer obtains lengths of steel pipe and a copper ground rod from a local supply house. The CM106K is primarily intended for overseas shipments.


Specifications

Vertical Load Limit 45 kg (100 lb)
Leveling Adjustment Clamp brackets on each leg adjust individually.
Maximum Slope Angle 22° or 40% grade (Maximum slope angle assumes that one leg points downhill while the other two legs point uphill.)
Portability Collapsible to 23 cm (9 in.) diameter by 2.54 m (100 in.) length.
Leg Base 150 x 89 mm with one 21 mm hole for stakes (6 x 3.5 in. with one 0.84 in. hole for stakes)
Measurement Height 3.0 m (10 ft)
Mast Outer Diameter 48 mm (1.90 in.)
Base Diameter 3.4 m (11 ft)
Weight with Mast 30 kg (67 lb)

Maximum Allowable Wind

-NOTE- Allowable sustained wind values assume the following:
  1. Mast and leg components are made of steel (minimum yield strength of 36 ksi [248 MPa]) and fabricated according to the specified design.
  2. 14 x 16 in. enclosure at mast base
  3. 10.5 x 16.5 in. solar panel at mast base
  4. Crossarm and sensors (1.4 ft2 projected area) at mast top
  5. Adequate ground anchors (stakes can pull out at lower wind speeds)
Sustained Wind
  • 36 m/s (80 mph) unguyed
  • 51 m/s (115 mph) guyed
Wind Gust
  • 46 m/s (104 mph) unguyed
  • 67 m/s (150 mph) guyed