FAQs Frequently Asked Questions About our Products and Solutions

All FAQs (442 total: showing 141-160)

How do I renew my CELLDATA subscription?
What happens if my data use goes over the monthly allowance for my CELLDATA plan size?
If I have a CELLDATA plan, where can I find modem status information?
Are there any problems with locating a CS110 Electric Field Meter Sensor and an SG000 Strike Guard Lightning Sensor near a tower that has spread-spectrum radios on it?
Can the CPEC310 Scrub Module as a source of zero gas be used with the CPEC300 or CPEC306?
Can a CS110 be used to measure current flow and direction on electric transmission lines?
What can be done if an enclosure gasket becomes torn or damaged?
Why is the CS526-L not compatible with the CR300-series dataloggers?
On routine site visits, how can the calibration of the CS310 be checked?
How can the CS310 be mounted if the 18356 leveling base is not used?
Is it possible to read the output from a CS310 in a 4 to 20 mA form?
What is the difference between LoggerLink and LoggerNet Mobile Connect?
To prepare the molecular sieve, how many grams are needed per bottle?
Which countries can the molecular sieve be shipped to?
Why did Campbell Scientific start using molecular sieve? Does it have the same effect as the previously used chemicals?
Can molecular sieve be used in the future to replace bottles for gas analyzers sold before July 2017?
What might cause a battery to not hold its charge?
If a CS110 electric field sensor is installed in complex terrain, such as on a ridgeline in alpine territory, what is the effective range (spatial range) of the instrument, and how might it differ from a flatland site?
Does the CR1000X have a Thermistor() instruction similar to the CR6?
In the event that the CR1000X becomes damaged and needs a new wiring panel, what should be done?

Previous Next