All FAQs (386 total: showing 261-280)
- Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
- Is it possible to transfer data from PC400 directly to a database such as Oracle (possibly through ODBC on Windows)?
- What might cause the 014A-L to miss data, provide readings of 0 constant wind speed, and show various readings of gust speed?
- How do you change the bearings of this sensor?
- Is the CC640 a real-time camera?
- I am trying to communicate with my new CC640 with a WinXP Pro SP2 notebook. I installed the CSI Device Config Utility (v1.3 from the included cd) and did the Power On - Setup on the camera, but I get "The Device version number, 1, is not defined for device, 11." I tried downloading the newest Device Config Utility (1.4) but it didn't have the CC640 listed. How do I communicate?
- Would the SM4M replace an SM192 storage module or could I still get replacement battery for my SM192?
- How many data lines can a SM192 and a SM4M store using a simple program?
- Is there software that will allow the connection of SM4M to a laptop through a USB port since laptops do not often have a 9-pin com port?
- If a version of PC208 will not recognize a SM4M, is there a download that can be used to retrieve the data?
- I am looking for a net radiation and a solar radiation sensor for Idaho to be deployed during the summer and winter. Would the CNR1 be a good choice? I don't know if I will have enough power to use the heater consistently.
- How often is recalibration recommended for the CNR1?
- How high above the ground should a net radiometer be placed?
- What kind of a regulator would you recommend if I want to set up a manually-powered generator to charge a 12-V gel battery? I have access to a 24 volt generator, but would that be too much do you think?
- I have the CH12R (12V charger/regulator). I am trying to connect it to a 17.5-V, 290-mA, 5.1-W solar panel, to keep a 12-V battery charged. I just wanted to know how to go about doing this.
- How many solar panels can be connected to a CH100 regulator? Can one 60 W solar panel and two 20 W solar panels be connected to the same regulator?
- What might cause a PS100 or CH100 to fail after less than a year?
- I have a PS100 with a charging regulator inside my enclosure. I would like to charge it with 110 V ac power at my site. I want to run my 110-V power cable directly into the enclosure, and not use a wall-mount style transformer/charger. Do you sell an ac transformer that will go inside my enclosure or should I buy one locally? Also, what is the preferred transformer voltage for the PS100?
- What's new in SCWin 2.6?
- Can an NL100 be set up through DevConfig using a 17394 cable instead of an RS-232 null modem cable? Would a 17394 connected to an SC32B be basically the same as an SC-USB?
Previous
Next