Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

sampling 2 COM ports at different rates


pfjessen Sep 23, 2019 09:25 PM

I want to sample an IMU at 40 Hz and a sonic anemometer at 32 Hz (fastest it will sample). These are on two different COM ports. I can’t use a Subscan command because apparently the SerialInRecord command can’t be used in a subscan. I can’t use a SlowSequence command because the slowscan interval has to be greater than 100 msec. Does anyone know of a way to do this?

Log in or register to post/reply in the forum.