Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

date/time settings

PVAL May 31, 2017 12:25 PM

Good Morning!

I would like to know how I can set the date and time in a CR1000 logger. Is this possible only in loggernet?

thanks

* Last updated by: PVAL on 5/31/17 @ 12:28 PM *
GaryTRoberts Jun 5, 2017 02:13 AM

If the logger is connected to the internet via TCP/IP, you can do it programatically in CRBasic using the NetworkTimeProtocol() instruction.  Connecting a GPS16X-HVS to the datalogger, it can be used to adjust the datalogger's time with the GPS() instruction.

Log in or register to post/reply in the forum.