All FAQs (442 total: showing 301-320)
- If an existing wind set is replaced with a wind monitor (05103-L, 05103-45-L, 05106-L, 05305-L), will more than the multiplier and offset have to be changed in the data logger program?
- We have an R.M. Young marine anemometer with a cable that is about 13 ft long. We would like to extend the cable another 20 ft or so. Do you sell a separate extension cable for the anemometer?
- What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
- What is the procedure for orienting my wind sensor to the cardinal directions so that the wind direction readings are correct?
- How can the 229-L be calibrated?
- How are readings obtained from the 229-L?
- Is calibration of the 229-L available?
- If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
- To use a multiplexer with a CR10X and very low sensor signals (1 mV and lower), should an AM25T or an AM16/32 be used? For which sensor signal voltages and sensor impedances can the AM25T and the AM16/32 be used?
- How should the AM25T be used?
- Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
- What is the measurement resolution, in Hertz, of the AVW1, AVW4, or AVW100? Do these interfaces have any certifications of compliance?
- Does the AVW100 work with Edlog Instruction 28 or 131?
- How can the data logger build a text string and send it out the RS-232 port?
- What is needed to write a simple program that will read two analog channels (0 to 10 Vdc)?
- Instead of purchasing the entire 03001-L R. M. Young Wind Sentry Set, can I purchase just the Wind Sentry anemometer or Wind Sentry wind direction sensor to replace a bad unit from a previously purchased set?
- I plan to set up an eddy covariance system in a remote wetland located in Michigan's upper peninsula. This site does not have power and is difficult to get to. I would like to set up a communication system that allows me to monitor the data from my office (Michigan Tech). There is a research station near the site (less than 5 km away--Seney National Wildlife Refuge) that could be used to collect the data before bouncing it to me.
- I am writing from Universidad de Cuenca in Ecuador, and I would like to know if we can use ST-20 Argos Satellite Transmitter in Ecuador? Are there other choices for Ecuador?
- Do Campbell systems support other satellite networks such as Iridium and Orbcomm? If the answer is "yes", do you know if the area of Somalia is covered by those services?
- I need help with a satellite telemetry system to be used in northern Somalia for hydrological and meteorological station data transfer for a flood early-warning application.
Previous
Next