Compatible with most Campbell Scientific dataloggers
Overview
The CMP3, manufactured by Kipp & Zonen, is an ISO-second-class pyranometer that monitors solar radiation for the full solar spectrum range. It connects directly to a Campbell Scientific datalogger and is used for many meteorological applications.
Read MoreBenefits and Features
- Includes a white snap-on sun shield that reduces the sensor's temperature
- Measures reflected solar radiation when inverted
- Provides measurements in direct sunlight, under plant canopies, when the sky is cloudy, and in artificial light
- Includes bubble level and leveling screws, eliminating the need for a separate leveling base and simplifying installation
- Acceptable for providing the solar radiation data used in stability estimations
- Dome protects thermopile and allows water to roll off of it
- Designed for continuous indoor and outdoor use
Images
Detailed Description
The CMP3 measures solar radiation with a high-quality blackened thermopile protected by a dome. The blackened thermopile provides a flat spectral response for the full solar spectrum range, which allows the CMP3 to be used under plant canopies or lamps, when the sky is cloudy, and for reflected radiation measurements.
The CMP3 includes a white snap-on sun shield that reduces the sensor's temperature. It also has a bubble level and adjusting leveling screws, which enable the sensor to be leveled without using a leveling base.
The CMP3 produces a millivolt signal that is measured directly by a Campbell Scientific datalogger.
Two CMP3 pyranometers can be mounted back-to-back to make a low cost albedometer. Contact Campbell Scientific for more information.
Specifications
| Sensor | Blackened thermopile protected by a dome |
| Measurement Description | Monitors solar radiation for the full solar spectrum range |
| Spectral Range | 300 to 2800 nm |
| Maximum Irradiance | 2000 W/m2 |
| Sensitivity | 5 to 20 µV/W/m2 |
| Operating Temperature Range | -40° to +80°C |
| Temperature Dependence | ±5% (-10° to +40°C) |
| Non-Linearity | < ±2.5% (0 to 1000 W/m2) |
| Tilt Response | < ±2% at 1000 W/m2 (±80°) |
| ISO Classification | Class C (second class) |
| Dome Diameter | 3.2 cm (1.3 in.) |
| Width | 7.9 cm (3.1 in.) |
| Height | 6.7 cm (2.6 in.) |
| Weight | 600 g (1.2 lb) with 10 m (32.8 ft) cable |
Compatibility
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Dataloggers
| Product | Compatible | Note |
|---|---|---|
| CR1000 (retired) | ||
| CR1000X | ||
| CR300 | ||
| CR3000 (retired) | ||
| CR310 | ||
| CR350 | ||
| CR6 | ||
| CR800 (retired) | ||
| CR850 (retired) |
Additional Compatibility Information
Mounting
The CMP3-L includes a bubble level and adjusting leveling screws, which allow the sensor to be leveled without using a leveling base. The CM225 Solar Sensor Mounting Stand is typically used to attach the sensor to a mast, crossarm, or pole (1.0 in. to 2.1 in. outer diameter). The CM225 consists of a rectangular plate, mounting bracket, U-bolts, washers, lock washers, and nuts. The CMP3-L should be mounted away from all obstructions or reflective surfaces that might adversely effect the measurement.
Alternatively, the CM245 Adjustable Angle Mounting Stand may be used. It includes slots that can be adjusted to any angle from horizontal to vertical.